While we don’t currently sell it, you can help protect your DI-NOC™ and minimize scratches by applying 3M™ Tire Restorer. The tire restorer works by adding a thin layer of silicone that acts as a top coat to DI-NOC™ without changing the vinyl’s appearance. You shouldn’t confuse this with a clear-coat, which will add a shininess to the material.\r\n
\r\nIf you’re installing DI-NOC™ in an area that may receive high traffic and/or abuse, this is a great way to help ensure the vinyl stays looking good over time.
\r\n\r\nThis picture is the back of the carbon fiber vinyl after you remove the paper…so it’s the sticky part. Regular adhesive has a flat/smooth backing, but as you can see, this actually has a grid of squares. All of those little squares allow air to easily escape through microreplicated channels under the surface of the film as it’s being applied. The result is a much easier installation with less chance of air bubbles. On top of that, you would install the vinyl using the dry method, which means there is no need to use soapy water to apply. If you mess up, you can simply pull it back off and re-stick it.\r\n\r\nThis is just one of the many reasons why the carbon fiber vinyl we carry here at Carbon Fiber Film is the best out there.
